Bedroom Painted

Sherwin-Williams paint sale

sherwin williams paint sale on now

Get your house painting and your condo painting at a super saver cost.

Weekend you can buy any Sherwin-Williams premium paints at 40% off. These are great paints and they cover well and easy to paint with. They come in a variety of different sheen levels from flat and satin all the way to gloss finishes.

For the nice soft subtle look in a bedroom it is advisable to use a satin paint finish. This gives the room a warm feeling. This paint is also washable and touchable not leaving any paint marks from your brush or roller.

This paint has a very low odor and is good on the VOC. Sherwin-Williams paint colors are immense you can get any color you want in any shine level you want for anywhere you want. Make anything from your living room – dining room – hallway – kitchen – washroom – bedrooms.

They also make a great kitchen cabinets paint that you can also use on doors and baseboards and Windows. It is a tough enamel paint that resists scratching and ware.

In my opinion as a professional painting contractor Sherwin-Williams paints is considered to be the highest quality paint that a homeowner can purchase. It far exceeds any Behr paint from Home Depot and other paints from places like Rona, Lowe’s and Canadian tire. These companies I find their paints inadequate low on quality and performance. Even if you do the painting your self you’re much better off buying in this top line paint because your paint job will it be easier to do and look better even if you paid a little extra money for purchasing the paint.

[wpseo_map width=”400″ height=”300″ zoom=”-1″ map_style=”roadmap” scrollable=”0″ draggable=”0″ show_route=”0″ show_state=”1″ show_country=”1″ show_url=”1″][wpseo_address show_state=”1″ show_country=”1″ show_phone=”1″ show_phone_2=”0″ show_fax=”1″ show_email=”1″ show_url=”1″ show_opening_hours=”1″]

Basement Wall Paneling

Wood Paneling in Mississauga

Basement wall paneling
Basement wall paneling

Basement Wall Paneling  in Mississauga

Recently we had to open up a Basement Wall Paneling from the 80s. Sometimes people wood panel over important things such as electrical outlets and  water taps to shut off the water for the outside garden hose. In this particular case the customer was going to paint all the paneling in the basement here in Mississauga. This made it easy to just cut the wood paneling trying to locate the outside garden tap shut off valve.

 

When we were finished locating the water shot off valve we had to close the hole back by reinserting the paneling we just cut out. Since the piece of panel was cut out from a non-supported section  of panel (no studs here) in the wall we  had to install some strips of wood behind to secure the peace together.

 

Note, it is wise to cut the hole as uniform and square as possible is a nice clean straight cut preferably on some kind of a fault line. So when you go to put this back in the place it should line up nicely and the faultlines camouflage the cut joint.

 

In this case since the paneling in the basement will be painted it will be easy to plaster repair the joint with some fiber tape and some sandable plaster. The fiber tape is used instead of regular tape because it’s a little stronger than using tape and places were there’s a little bit of vibration in the wall since paneling is not as secure and solid as drywall. Furthermore in this case we also used some exterior plaster which has some vinyl content mixed in with it to give it some flexibility.

 

Once the plaster was done we primed the wood panel repair to a nice flat finished smooth surface being careful not to leave any humps or bumps or unsanded edges.

 

It is wise though to paint wood paneling that is old like this one was with a very low luster if not flat or velvet finish. Also make sure that there are no stains in the wood paneling because they will bleed through the paint job. Sometimes it’s wise to check all your walls to make sure that there are no pen marks crayon or felt marker marks. If this is the case then you should prime the spots with some kind of spot sealer such as binz or kilz to seal any stains.

 

Also paneling usually has open joints between panels and when you paint the walls you will see all these joints easily. To overcome these joints and to fix them we usually use latex caulking to lightly and smoothly fill these joints in.

Usually it takes  three coats of latex paint to give all your wood paneling a nice finished look.

[wpseo_map width=”400″ height=”300″ zoom=”-1″ map_style=”roadmap” scrollable=”0″ show_route=”0″ show_state=”1″ show_country=”1″ show_url=”1″][wpseo_address show_state=”1″ show_country=”1″ show_phone=”1″ show_phone_2=”0″ show_fax=”1″ show_email=”1″ show_url=”1″ show_opening_hours=”1″]